User’s Guide ValueJet 1304
Installing the unit
AP-75780 - Revision 1.3 31
3
3.3.2 Replacement steps
Step 1: Verify that the printer has been switched ON.
Step 2: Remove the empty ink cassette from the ink cassette slot.
Step 3: Unpack the next ink cassette and insert it into the cassette slot.
Step 4: Verify that the printer returns to the Normal mode.
Note
Do not shake ink cassettes. Doing so may cause ink leakage
Do not disassemble the ink cassette. A disassembled ink cassette cannot be
used.
When an ink cassette is moved from a cold place to a warm place, keep the ink
cassette unused for 3 hours or more in the printing environment.
Do not refill the ink cassettes.
Doing so may result in incorrect printing.
Insert or remove the ink cassette at the time of replacement only.
Inserting or removing ink cassettes except at the time of replacement may
result in incorrect printing.
Note
Do not replace ink cassettes when the printer is switched OFF. Doing so may
result in incorrect detection of the remaining ink and result in abnormal
printing behaviour.
Note
Put used ink cassettes in a vinyl bag or a bag used for this kind of waste.
Disposal of an ink cassette has to be done in compliance with the regulations
and instructions of the local authorities.
Note
Open the ink cassette solvent resistant blister just before attaching the ink
cassette into the cassette slot. Leaving the ink cassette open for a long time
may result in an abnormal print.
Replace the ink cassette within 6 months after installing it into the printer.
Insert or remove the ink cassette not more than 10 times. This to prevent that
the smart chip or its reader would be worn out and malfunction in this way. If
inserted or removed more than 10 times the ink cassette could malfunction
even if there is some ink remaining.
Note
The printer resumes printing when you have replaced (and) ink cassette(s)
after an ink end occurred during printing.
To Next Page
Loading...
