EasyManua.ls Logo

MUTOH ValueJet 1304 - Panel Setup Menu

MUTOH ValueJet 1304
124 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User’s Guide ValueJet 1304
Handling the printer
62 AP-75780 - Revision 1.3
4.6 Panel Setup Menu
In the table below you will find the complete menu structure and its functions.
Setup item Description
MediaType Set up the media type for printing
Effect Set up the effect menu
Flushing Set up the flushing operation while printing
Side Margin Set up the right and left margin when printing
Media initial
Set up whether the media width and edge are detected when
initializing the media.
Media Width/
MediaWidth Check
Specifies the media width between the loading mark and the left end
if media detection is not performed during media initialization.
Displays the detected media width if media detection is performed
during media initialization.
Take-up Set to on when using a take-up system
Origin Set the start position of the printing data
Prev. Stick Set up to prevent media from sticking when printing.
MediaCut Sets the media cutting operation after finishing printing.
CR movement Set up the distance to move the print head while printing.
OverwriteCnt Set up the Overwrite Cnt per swath.
Overwrite Wait Set up the waiting time while overwrite printing
Slant Check Set up the slanting detecting between two consecutive print jobs.
Auto Cleaning Set up the auto cleaning time while printing.
Ink Status
Display the remaining ink level of the ink cassette that was installed
into the ink cassette slot
Roll Length Set up the roll media length.
Head Wash Perform a head wash
CR Maint.
Unlocks the carriage from the home position in order to be able to
clean the wiper.
Initialization
The parameter values of the printer are restored to their factory
defaults.
Life Times Display the operational life time of each part
IP Address Set the IP address of the printer
Subnet Mask Set the subnet mask of the printer
Gateway Set the Gateway.
Front Interlace Set the front treatment function.
Temp o r a ry
The settings of “OFF” or “ALL OFF” in the Selection menu are
displayed in the setup menu temporary.
--- CANCEL: shifts to the previous hierarchy.

Table of Contents

Other manuals for MUTOH ValueJet 1304

Related product manuals