7. Using Remote Management
Specify the type of access limitation.
Allow All
Permitted address
Allow All
Specify the IP addresses to be permitted or blocked by
delimiting them with "," (comma). "*" (asterisk) can be used as
a wildcard.
Ex.) 192.168.1.*,192.168.2.1,192.168.2.254
(*1) Addresses and character strings are example.
(*2) Factory-set value.
(*3) Use Management LAN port to access to BMC.
(*4) Share system LAN port to access to BMC. This setting is valid only on the server that supports Shared LAN.
This server does not support Shared LAN.
(*5) This item can be changed when "Management LAN" is selected. Be sure to use straight cable to use the
communication type of 10Mbps, 100Mbps, or 1Gbps. If Auto Negotiation is used on the destination (such as
hub), the management LAN must use the same setting. To use any other setting than Auto Negotiation, first
change setting on destination, then the management LAN.
(*6) Displayed when DHCP is enabled.
(*7) Specify whether the IP address used for accessing BMC is permitted or blocked.
(*8) Displayed when limitation type is "Permitted Address" or "Blocked Address".
(*9) The default IP address of standby BMC is 192.168.1.101.
(*10) Not displayed on standby BMC. When DHCP is enabled, this is used as DHCP client ID of master BMC.
Buttons
① [Apply] button
Apply the edited value and return to List page.
② [Default] button
Set the factory-set value. This value is not applied unless [Apply] button is pressed.
③ [Cancel] button
Return to List page without applying the edited value.
• Setting of "Permitted Address" and "Blocked Address" are common to IPv4 Property
(Standby).
• While editing "Permitted Address" or "Blocked Address" on IPv4 Property (Master), do
not edit them on IPv4 Property (Standby) on web console of another session, and vice
versa.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
319
To Next Page
Loading...