NEC SL1100 - Table 1-7 Keys for Entering Names

6. Dial the Speed Dial bin in which the number is to be stored. If you press Hold key, the next
available Speed Dial bin will be used. The display shows:
ABB XXXX:
xxxxxxxxxxxxx
If all Speed Dial bins are used, the display shows “TABLE IS FULL”.
7. Press Hold key. The display shows:
ABB XXXX
-
8. Enter the name to be associated with the stored number.
Table 1-7 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 0
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters: 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В
*
Enter characters:
*
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed -
ex: TOM). Pressing # again = Space. (In system programming mode, use the
right arrow Softkey instead to accept and/or add a space.)
Clear/Back or DND Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
9. Press Hold key. The display shows:
SET ABB
10. Press Speaker key.
The telephone returns to idle.
Storing a Number (When 15-02-60: 1 or 2)
To store a Caller ID number in a Common Speed Dial bin:
SL1100
ISSUE 2.0
1-124
Caller ID
C