NEC SL1100 - Table 1-52 Caller ID Sent to Mobile Telephone

*
Only when the outbound trunks are ISDN or SIP trunks.
**
ISDN will need to accept the inbound Caller ID as the Calling Party Number (CPN) presentation for
the outbound call.
Table 1-52 Caller ID Sent to Mobile Telephone
Inbound Trunk Outbound Trunk Y/N
Analog CID CFA Analog N
Analog CID CFA ISDN PRI/SIP Y
ISDN PRI CFA ISDN PRI/SIP Y
ISDN PRI CFA Analog N
Analog CID CFNA Analog N
Analog CID CFNA ISDN PRI/SIP Y
ISDN PRI CFNA ISDN PRI/SIP Y
ISDN PRI CFNA Analog N
Conditions
• If the extension has Call Forward-Both Ring set to another extension, it will only continue to forward
if the Both ring location is forwarded (B/NA or NA) to VM and no where else.
• Analog, ISDN and SIP trunks are supported for the outbound call to the Mobile Extension.
• It is recommended that this feature uses ISDN platform (as these trunks provide answer
supervision).
• The analog line must provide CLI information to allow the Mobile Extension to dial into the system to
access features.
• For the extension DTMF, the minimum Detect Level for the DTMF Tone (PRG 80-03-03) must be
set to allow a minimum detection level of -25dBm. This entry is dependent on the Detect Level
selected in PRG 80-03-01.
• The Mobile Extension uses the
*
to perform a flash, so any service codes which begin with
*
must
be changed (PRG 11-10, PRG 11-11, PRG 11-12, PRG 11-13).
• To provide a proper disconnect, Disconnect Supervision is required for the trunks used for this
feature.
• When an entry is made in PRG 15-22-01 for a Mobile Extension, ports are reserved for Mobile
Extension usage in groups of 4.
• To keep consecutive port numbering for units, you may wish to consider starting Mobile Extensions
at the upper extension port range.
• Calls on Mobile Extension can be easily picked up from a telephone in the system. This is done via
a Barge-In key (34+Mobile Ext # or 34+
*
)
*
will Barge-In to the Extension that Call Forward Both
Ring is set to. If no Forward Both Ring is set, the key will act as a basic Barge-In key.
• If the main terminal has call forward both ring set to the Mobile Extension and the Ecology-Power
Cutting feature removes power to the terminal any calls sent to the terminal will not go to the Mobile
Extension.
Default Settings
No Mobile Extensions are configured.
SL1100
ISSUE 2.0
1-514
Mobile Extension
M