NEC SL1100 - Figure 1-31 PC Programming Overview; Figure 1-32 Pcpro Connection Dialog; PC Programming

PC Programming
Description
The SL1100 has three different methods for programming. The first is via the Telephone, the second
is by PCPro and third by WebPro.
PCPro is a Microsoft Windows based application. It allows the technician/system administrator to
download a database from the system, make changes, and then upload.
The WebPro application is a browser base. It allows the technician/end user to make a change to the
system/terminal. No special installation program is required.
An overview of the three programming applications is shown below.
KSU
WebPro
(IP)
PCPro
(IP)
Telephone
PCPro
(Modem)
Figure 1-31 PC Programming Overview
Connecting
As can be seen in Figure 1-31 PC Programming Overview on page 1-576, three connection types are
available to PCPro/WebPro.
PCPro, user can connect directly or remotely using a modem/LAN. A connection with the system is
made via the Connection Dialog in the application. (Refer to Figure 1-32 PCPro Connection Dialog on
page 1-577.)
• Modem (remote) connections are established via the internal VMDB modem. To access the modem,
dial a trunk that is directed to the modem access service code (DIL or DID) or dial an extension that
is redirected to the modem access service code. When connecting with a Modem, a Dial Up
Connection (PPP) must be set up in Windows Network Connections.
When uploading via a Dial Up connection, uploading card configuration (Hardware Upload) is not
supported.
• IP (LAN) connections are established by connecting the LAN cable to CPU Unit.
SL1100
ISSUE 2.0
1-576
PC Programming
P