NEC SL1100 - Figure 1-36 Navigation Bar; Table 1-55 Package List for Drag & Drop

1. Data Link
2. Intuition Setup
Figure 1-36 Navigation Bar
1. Data Link
Data Link shows "Intuition QA" at default (Initial data base) to enter Intuition Setup. Once after any
system data was changed this area shows H/W setting and jump to H/W setting screen directly.
For detail H/W settings, refer to Table 1-61 Intuition Setup HW Setting on page 1-592.
2. Intuition Setup Tab
Intuition Setup Tab shows link to Intuition Setup and "Data Link".
Slide Panel
Slide Panel provides Drag & Drop feature for packages and terminals. Supported packages and
terminals are shown in below table.
To remove packages or terminals, select "None" from Slide Panel and Drag & Drop to required slot or
port like a PCPro Card Configuration.
Table 1-55 Package List for Drag & Drop
Package type
Description Note
084M Dedicated to slot 1, 4 and 7.
084M+4COI Dedicated to slot 1, 4 and 7.
4COIDB can be set on 084M, 080E, 008E and 000E (V1.5 Added).
080E 080E can be set to slot 2, 3, 5, 6, 8, or 9.
080E+4COI 080E can be set to slot 2, 3, 5, 6, 8, or 9.
4COIDB can be set on 084M, 080E, 008E and 000E (V1.5 Added).
008E 008E can be set to slot 2, 3, 5, 6, 8, or 9.
008E+4COI 008E can be set to slot 2, 3, 5, 6, 8, or 9.
4COIDB can be set on 084M, 080E, 008E and 000E (V1.5 Added).
SL1100 ISSUE 2.0
1-586
PC Programming - Intuition Setup
P