NEC SL1100 - Figure 1-37 Intuition Setup Page 1 - Trunk Setting; Table 1-56 Terminal List for Drag & Drop; Table 1-57 Trunk Types

Package type Description Note
000E+4COI 000E can be set to slot 2, 3, 5, 6, 8, or 9.
4COIDB can be set on 084M, 080E, 008E, 000E.
(V1.5 Added)
PRI PRI can be set to slot 2, 3, 5, 6, 8, 9, 10, 11 or 12.
Limited one unit (PRI or PRI (T1)) per KSU and two units (PRI or PRI (T1)) per
system.
(V1.5 Changed)
PRI (T1) PRI can be set to slot 2, 3, 5, 6, 8, 9, 10, 11 or 12.
Limited one unit (PRI or PRI (T1)) per KSU and two units (PRI or PRI (T1)) per
system.
(V1.5 Changed)
MEMDB+VOIPDB MEMDB+VOIPDB is dedicated to slot 0.
InMail InMail is dedicated to InMail slot.
Table 1-56 Terminal List for Drag & Drop
Terminal type Description
MLT MLT can be set to Multiline Terminal port of 080E and 084M.
SLT SLT can be set to Single Line Terminal port of 008E and 084M.
Doorphone DoorPhone can be set to Single Line Terminal port No.3 and 4 of 084M.
Maximum 6 Doorphones can be set in a system.
DSS DSS can be set to any Multiline Terminal port of 080E and 084M.
Maximum 12 DSS consoles can be set in a system.
Intuition Setup Page 1 - Trunk Setting
"Intuition QA" linked to following "Intuition setup page 1". At this screen Trunk type resources can be
configured. Settings are stored once "Next" is clicked.
Figure 1-37 Intuition Setup Page 1 - Trunk Setting
Table 1-57 Trunk Types on page 1-588 shows the type of Trunks supported at the "Intuition setup
page 1".
ISSUE 2.0
SL1100
Features and Specifications Manual 1-587
P