NEC SL1100 - Page 237

Direct Call by Time Schedule: (V2.0 or higher)
Program
Number
Program Name Description/Comments Assigned Data
11-10-35 Service Code Setup (for Admin-
istrator) - Dial-In Mode Switch-
ing
Assign the service code Dial-In Mode
Switching.
MLT, SLT
(default not assigned)
12-04-01 Holiday Night Service Switching Assign a yearly schedule of night-
switch(Holiday) setting. This schedule is
used for setting of special days when the
company is expected to be closed, such
as National Holiday, Summer Vacation,
etc.
Night Mode Service Group
No.; 01-32
Days and Months: 0101 ~
1231
(e.g. 0101 = Jan. 1; 1231
= Dec. 31)
Time Pattern Number: 0 ~
10
(0 = No Setting)
(default not assigned)
15-07-01 Programmable Function Keys Assign a function key for one-touch ac-
cess to the Dial-In Mode Switching setup
code (Code 88).
Line Key 1 ~ 24
0 ~ 99 (Normal Function
Code 751 by default)
*
00 ~
*
99 (Appearance
Function Code)
(Service Code 752 by de-
fault)
20-07-26 Class of Service Options (Ad-
ministrator Level) - Dial-In Mode
Switch
Enable/ Disable an extension user ability
to manually change Dial-In Modes.
0 = Off
1 = On
(default = 1 for COS 1~15)
22-02-01 Incoming Call Trunk Setup For each Night Service Mode, enter serv-
ice type 8 when the trunk should be a
DID (DDI) Mode Switching trunk.
Trunks 1 ~ 84
0 = Normal
1 = VRS (second dial tone
if no VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID (DDI) Mode
Switching
(default = 0)
22-11-02 DID Translation Number Con-
version - Target Number
For each DID Translation Table entry
(1~800), specify the extension the sys-
tem dials after translation.
Do not assign Received Digits in PRG
22-11-01 when using DID Call by
Time Schedule.
Maximum 36 digits
(default not assigned)
22-17-01 Dial-In Conversion Table Area
Setup for Time Pattern - Re-
ceived Dial
Define the received numbers for each Di-
al-In Conversion Table (PRG 22-17-02,
22-17-03 and 22-17-04).
Up to eight digits
(default not assigned)
22-17-02 Dial-In Conversion Table Area
Setup for Time Pattern - Start of
Time
Define the Starting Time for each DID
Translation table in PRG 22-17-01.
0000~2359 (Time)
(default = 0000)
22-17-03 Dial-In Conversion Table Area
Setup for Time Pattern - End of
Time
Define the Ending Time for each DID
Translation table in PRG 22-17-01.
0000~2359 (Time)
(default = 0000)
22-17-04 Dial-In Conversion Table Area
Setup for Time Pattern - Dial-In
Conversion Table Number
Assign each time pattern to a DID Trans-
lation Table Entry in PRG 22-11.
0~800
(default = 0)
ISSUE 2.0 SL1100
Features and Specifications Manual 1-225
D