NEC SL1100 - Page 24

3. Dial the Station Speed Dial buffer number to be programmed (0~9).
1 = Station Speed Dial Buffer 1
2 = Station Speed Dial Buffer 2
3 = Station Speed Dial Buffer 3
4 = Station Speed Dial Buffer 4
5 = Station Speed Dial Buffer 5
6 = Station Speed Dial Buffer 6
7 = Station Speed Dial Buffer 7
8 = Station Speed Dial Buffer 8
9 = Station Speed Dial Buffer 9
0 = Station Speed Dial Buffer 10
4. Dial the telephone number you want to store (maximum of 36 digits).
Valid entries are 0~9, # and
*
.
A Single line set cannot program a pause or flash in a spd bin.
5. Hang up.
To dial a Station Speed Dialing number (Multiline Terminal):
1. Press Speaker key.
2. Dial #7 (default Service Code).
- OR -
Press the System Speed Dialing key (Service Code 751: 27).
To preselect, press a line key in step 1 (instead of Speaker).
3. Dial the Station Speed Dial buffer number (0~9).
1 = Station Speed Dial buffer 1
2 = Station Speed Dial buffer 2
:
:
0 = Station Speed Dial buffer 10
The stored number dials out.
Unless selected by the user, Trunk Group Routing selects the trunk for the call. The system may
optionally select a specific Trunk Group for the call.
If you have a DSS Console, you may be able to press a DSS Console key to chain to a stored number.
To dial a Station Speed Dialing number (Single Line Terminal):
1. Lift the Handset.
2. Station Speed Dial #7
Group Speed Dial #4
System Speed Dial #2
3. Dial the Speed Dial Memory Location.
Station Speed Dial 0~9
Group Speed Dial xxx (none at default)
System Speed Dial 000~999
4. Converse.
SL1100
ISSUE 2.0
1-12
Abbreviated Dialing/Speed Dial
A