EasyManua.ls Logo

NEC SL1100 - Page 454

NEC SL1100
864 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The VoIPDB uses two addresses, one address is for signaling and the other address for voice
traffic.
An on-board RJ-45 connector provides a WAN/LAN connection. Voice and signaling data to/from
the IP Stations are converted into IP Frames and transmitted through the Data Communication IP
Network.
The VoIPDB supports a maximum of 32 VoIPDB connections.
Duplex mode (Auto or Full) and speed (10 or 100 mbps) are configured via SL1100 unit
programming.
In voice communication, particularly Internet telephony, the Mean Opinion Score (MOS) provides a
numerical measure of the quality of human speech at the circuit destination. The scheme uses
subjective tests (opinionated scores) that are mathematically averaged to obtain a quantitative
indicator of the system performance. The maximum MOS is 5.0.
SL1100 supports a 100 rel option and Session Timer option.
SL1100 supports Early Media.
SL1100 SIP restricts an outgoing call under the following conditions:
- SIP configuration failed
- SIP registration failed
- Lack of VoIPDB resource
- Lack of a VoIPDB bandwidth
Both port numbers can be configured by system data.
ToS Support.
Conditions
Documentation for Polycom devices are available at http://www.polycom.com/voicedocumentation.
Quick User Guides for supported Polycom devices are available at http://www.necntac.com under
Technical Documentation/Telephony/Polycom Soundstation (valid Username and Password
required).
SIP Stations which support RFC 3842 (Message Waiting) receive Message Waiting Lamp
indications.
SIP Station - VoIPDB does not support NAT traversal.
SIP Station - VoIPDB does not support a Blind Transfer feature.
Supports video codecs H.264, H.263, and H.261.
Video is supported when P2P for standard SIP is turned on. (PRG 10-26-03 SIP Peer-to-Peer Mode
ON)
Auto start video when call is answered is not supported.
SIP Station and SIP Trunk require a license key for activation. Once activated, the SIP Client
license may be shared between SIP Station and SIP Trunks.
SIP protocol (RFC3261) is used.
SIP Station uses the VoIPDB as a media gateway.
Default UDP listen port for a SIP station is 5070. Both port numbers can be configured by system
data.
SL1100 Station registration policy supports an authentication feature. Enabling this policy prevents
the registered telephone from unexpected override.
SL1100 supports HOLD and TRF feature on the basis of IETF draft.
- draft-ietf-sipping-service-examples-09.txt
- Section 2.5 (Transfer - Attended) of draft-ietf-sipping-service-examples-15.txt
- draft-ietf-sip-session-timer-10.txt
When all VoIPDB DSP resources are busy, the SIP Terminal cannot preempt active calls to make a
911 call.
The SL1100 CPU is the registration server for the SIP stations. The configurable IP Address is
located in PRG 10-12-09 (SL1100 Network Setup - IP Address).
SL1100
ISSUE 2.0
1-442
IP Single Line Terminal (SIP)
I

Table of Contents

Other manuals for NEC SL1100

Related product manuals