Call Routing - Inbound (DID)
Program Num-
ber
Program Name Default
22-01-06 System Options for Incoming Calls - DID Ring-No-Answer
Time
Use this program to assign the amount of time that a call will
ring the DID Transfer Target before overflowing to Transfer
Destination Number 1.
0 ~ 64800 seconds
(default)
20
22-01-07 DID Incoming Ring Group No Answer Time
Use this program to assign the amount of time that a call will
ring the Transfer Destination Number 1 before overflowing to
Transfer Destination Number 2.
This timer also controls the amount of time that a call will ring
the Transfer Destination Number 2 before overflowing to the
DID Intercept Ring Group.
0 ~ 64800 seconds
(default)
20
22-02-01 Incoming Call Trunk Setup - Incoming Type
ISDN PRI or SIP trunks at any location can send a DID directly
to any extension number in the SL Net network.
Trunks must be set to type (3) DID to follow the digit conver-
sion tables.
0 = Normal
1 = VRS
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie Line
6 = Delay VRS
7 = ANI/DNIS
8 = DID (DDI) Mode Switching
(default)
0
22-11-01
*1
Received Number
Enter the digits received from the Telco that are going to be
translated.
The amount of digits entered should be equal to the setting as-
signed in PRG 22-09-01.
Maximum of 8 digits (0 ~ 9,
, #, @)
(default)
not assigned
22-11-04 Transfer Operation Mode
The transfer operation mode allows DID calls to have more
routing options than just the target number. If the transfer oper-
ation mode is set to "No Transfer", calls will only be delivered
to the Target Number specified in PRG 22-11-02. If set to one
of the three other modes, it will follow that mode through all as-
signed transfer destinations.
0 = No Transfer
1 = Busy
2 = No Answer
3 = Busy/No Answer
(default)
0
22-11-05 DID Translation Table Number Conversion - Transfer Des-
tination Number 1
SL Net allows calls to overflow to a Centralized Voice Mail
from any location using a setting data of 103. When 103 is as-
signed, calls will overflow to the pilot number defined in PRG
45-01-07.
If the transfer operation mode is set (PRG 22-11-04), and one
of the conditions is met, calls will overflow from the target num-
ber to the destination in this program. If this was a No Answer
condition, calls would overflow to this program after the timer
in PRG 22-01-06 expires.
0 = No setting
1 ~ 25 = Ring Group 1 ~ 25
102 = Voice Mail (Call goes to the VM
pilot assigned in PRG 45-01-01)
103 Centralized Voice Mail (if central-
ized VM is enabled this setting is used
to route calls to the VM)
201 ~ 232 = Department Group 1 ~ 32
401 = DISA
501 ~ 599 = DISA/VRS Message (VRS
message number 1 ~ 99)
1000 ~ 1999 = Speed Dial Bins 000 ~
999
(default)
0
SL1100 ISSUE 2.0
1-690
SL Net
S
To Next Page
Loading...
