Guide to Feature Programming
Program
Number
Program Name Default Note
10-09-01 DTMF and Dial Tone Circuit Setup Resource 01 - 96 = 0 (Common)
11-12-14 Service Code Setup (for Service Access) -
Trunk Group Access
704
14-02-11 Analog Trunk Data Setup - Next Trunk in
Rotary if No Dial Tone
0
14-05-01 Trunk Group - Trunk Group Number Trunk Port 1~84 = Priority 1~84
14-06-01 Trunk Group Routing - Priority Order
Number
Route 1, Order Number 1 = 1 (Trunk Group 1)
Order Numbers 2, 3, 4 = 0 (Not Specified)
All Other Routes (2~25) and Order Numbers
(1~4) = 0 (Not Specified).
14-07-01 Trunk Access Map Setup - Trunk Port
Number
Access Map 1~84 = Trunk Ports 1~84 as-
signed with option 7 access (incoming and
outgoing access and access when trunk is on
Hold).
15-06-01 Trunk Access Map for Extensions 1
15-07-01 Programmable Function Keys Refer to Programming Manual.
20-02-02 System Options for Multiline Telephones
- Trunk Group Access Key Operating
Mode
0
20-29-01 Timer Class for Extension - Day/Night
Mode 1~8, Class Number
0
20-31-04 Timer Class Timer Assignment - Intercom
Interdigits Time (Intercom I/D Timer)
10 (seconds)
21-01-02 System Options for Outgoing Calls - In-
tercom Interdigit Time
10 (seconds)
21-01-05 System Options for Outgoing Calls - Dis-
connect Time When Dial Tone Not Detec-
ted
3 (seconds)
Operation
To place a call over a Trunk Group
1. At the Multiline Telephone, press Speaker key.
- OR -
At the Single Line Terminal, lift the handset.
2. Dial 704.
3. Dial trunk group number (001~025).
4. Dial number.
- OR -
1. Press the Trunk Group key (PRG 15-07 or SC 752:
To Next Page
Loading...
