11. Enter the VDSL settings as described in the following table.
DescriptionField
These settings are disabled because they do not apply to a VDSL connection.Multiplexing Method
VPI
VCI
Select the Use VLANID check box and enter the VLAN ID, as indicated by your ISP.
A VLAN ID might be required if you subscribe to both Internet service and IPTV
service. In some unusual situations, a VLAN ID is required for VDSL Internet service.
If your ISP did not provide you with a VLAN ID, leave the Use VLANID check box
cleared, which is the default setting.
Use VLANID
If your ISP provided you with a VLAN ID and a priority value, enter the priority value,
which is a number from 0 to 7.
You can enter a priority value only in combination with a VLAN ID. If your ISP did
not provide you with a priority value, leave the default setting (0).
Priority (0 ~ 7)
This setting is an option that applies to the IPTV interface only.
For information about configuring bridge mode, see Enable Bridge Mode for IPTV
Devices on page 202.
Bridge Mode
For a PPP over Ethernet (PPPoE) connection, select PPPoE (PPP over Ethernet)
from the menu.
PPP over ATM (PPPoA) is not supported for a VDSL connection.Note
Encapsulation
Enter the login name that you use to log in to your Internet service, as indicated by
your ISP.
This login name is often an email address.
Login
Enter the password that you use to log in to your Internet service, as indicated by
your ISP.
Password
Enter the service name that you use to log in to your Internet service, as indicated
by your ISP.
Often, a service name is not required.
Service Name
Manage the Internet Settings Manually
67
Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000
To Next Page
Loading...
Need help?
General
Weight and Dimensions
