GS108T Smart Switch Software Administration Manual
Managing Firmware and Reset Options 5-5
v1.0, May 2007
2. Click Factory Reset to reset the system.
• If there is no DHCP server on the network, the IP address will become 192.168.0.239.
• The password will return to the factory default password.
Reset
Reset enables you restart the switch with its current configuration.
To reset and restart the switch:
1. Click Reset in the blue navigation panel. A screen similar to that shown below appears.
.
2. Click Reset to restart the switch.
Note: You can also use the Reset button on the front panel to reset the switch to its current
configuration.
Figure 5-62
To Next Page
Loading...
