GS108T Smart Switch Software Administration Manual
3-12 Managing System Settings
v1.0, May 2007
a. Click Add on the Static Addresses screen. A screen similar to that shown below appears.
.
b. Input the required information in the provided fields:
• Interface Port: Select the interface port to which the entry refers.
• MAC Address: Enter the MAC address to which the entry refers.
• VLAN ID: Select the VLAN ID number to which the entry refers.
c. Click Apply to add the static address.
Removing a static address from the Static Addresses list
a. Check the static addresses on the Static Addresses page that need to be removed.
b. Click Apply to remove the static addresses.
Dynamic Address
1. Click Dynamic Address in the blue navigation panel. A screen similar to that shown below
appears.
Figure 3-11
To Next Page
Loading...
