GS108T Smart Switch Software Administration Manual
4-30 Configuring the Switch
v1.0, May 2007
• IGMP Function: allows to enable/disable the IGMP snooping feature per switch. This
feature is disabled by default.
• Dynamic Multicast Entry Table: displays the Dynamic Layer 2 multicast entries.
VID is VLAN ID.
• Multicast Entry: Layer 2 multicast group address.
• Member Port(s): the membership associated with the group.
3. Click Apply.
Unknown Multicast
The Unknown Multicast page allows you to enable or disable the unknown multicast flooding
feature.
1. Click Unknown Multicast in the blue navigation panel. A screen similar to that shown below
appears.
.
2. Enable or disable the unknown multicast flooding feature.
3. Click Apply.
Figure 4-49
To Next Page
Loading...
