GS108T Smart Switch Software Administration Manual
4-20 Configuring the Switch
v1.0, May 2007
.
2. View the LACP settings:
• LACP System Setting: Set LACP System Priority.
• Interface Priority: LACP Port priority ranges from 0 - 65536.
• Interface Timeout: Supports two modes of Timeout, Long/Short.
Monitor
The Monitor page allows you to configure any port's incoming and outgoing traffic to be mirrored
to a predefined sniffer port.
1. Click Monitor in the blue navigation panel. A screen similar to that shown below appears.
To Next Page
Loading...
