GS108T Smart Switch Software Administration Manual
1-8 Getting Started with Switch Management
v1.0, May 2007
• “Firmware Upgrade”
Password Change
You can set a new password of up to 20 ASCII characters.
1. Click Password Change from the Switch Setting section. The Password Change screen
appears. You can set a new password. In this process, you are required to enter the old
password and to confirm the new one.
2. Click Set to enable the new password.
Firmware Upgrade
.
If you click Firmware Upgrade from the main screen (see Figure 1-1 on page 1-3), after you have
selected the switch to upgrade, the following screen appears:
Note: You can also upgrade the firmware using the File Download menu of the switch
(see “File Download” on page 5-3).