GS108T Smart Switch Software Administration Manual
Configuring the Switch 4-19
v1.0, May 2007
• Delete: Checked lags will be deleted in Apply.
• LACP: Enable/Disable LACP for the selected LAG.
c. Click Apply to apply the changes.
3. Click LAG ID on the LAG Setting page. A screen similar to that shown below appears.
.
4. Modify the LAG membership.
5. Click Apply to apply the changes.
LACP
1. Click LACP in the blue navigation panel. A screen similar to that shown below appears.
Figure 4-40
To Next Page
Loading...
