NETGEAR ProSafe GS108

GS108T Smart Switch Software Administration Manual
4-18 Configuring the Switch
v1.0, May 2007
Click Link Aggregation in the middle part of the blue navigation panel to expand the item to
LAG Setting and LACP.
LAG Setting
1. Click LAG Setting in the blue navigation panel. A screen similar to that shown below
appears.
.
2. View the LAG settings:
• LAG Description: Description of the LAG.
• Link Status: Up/Down Status of the LAG.
• LAG Speed: The speed will be either Auto/10/100/1000 M.
• Duplex Mode: Half/Full duplex of the LAG.
• Auto Negotiation: On/Off status of auto negotiation.
• Back Pressure: On/Off status of back pressure.
• Flow Control: On/Off status of flow control.
• Member: List of the ports part of the LAG.
Figure 4-39