NETGEAR ProSafe GS108 User Manual

GS108T Smart Switch Software Administration Manual
Specifications and Default Values A-3
v1.0, May 2007
Trust MacAddress Filter 256 Disabled
Port -MAC lock down 8 (per port) Disabled
Management VLAN 1 0
Table A-6. Traffic Control
Feature Sets Supported Default
Rate control 8 (per port) Disabled
Storm control 8 (per port) Disabled
Jumbo frame 1 (per system) Disabled
Table A-7. System Setup
Feature Sets Supported Default
DHCP\Manual IP 1 192.168.0.239
System Name Configuration 1 NULL
Configuration Save/Restore 1 N/A
Firmware Upgrade 1 N/A
Factory Reset 1 N/A
Table A-8. Other Features
Feature Sets Supported Default
Static Multicast Entry 64 Disabled
Filter Multicast Control 1 Disabled
Table A-9. Management
Feature Sets Supported Default
SNMPv1/V2c 4 Disabled
MIB Support 1 Disabled
Table A-5. Security (continued)
Feature Sets Supported Default

NETGEAR ProSafe GS108 Specifications

General

MAC address table	8000 entries
Maximum data transfer rate	1 Gbit/s
Full duplex	Yes
Networking standards	IEEE 802.3ab, IEEE 802.3i, IEEE 802.3u
Copper ethernet cabling technology	1000BASE-T, 100BASE-TX, 10BASE-T
Latency	20 μs
Dimensions (WxDxH)	235.5 x 100.8 x 27 mm
Power requirements	5 V @ 2.8 A DC
Networking features	Ethernet, Fast Ethernet, Gigabit Ethernet
Switch type	Unmanaged
Basic switching RJ-45 Ethernet ports quantity	8
Noise level	0 dB
Mean time between failures (MTBF)	91.500 h
Power consumption (typical)	14 W
Safety	UL (UL 1950), CUL, C-Tick
LED indicators	Link, Power
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	10 - 95 %
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	760 g