NETGEAR ProSafe GS108 User Manual

GS108T Smart Switch Software Administration Manual
3-2 Managing System Settings
v1.0, May 2007
.
2. View the basic system information:
• Product name shows the switch model name.
• Firmware Version displays the software version of the switch.
• Protocol Version is the discovery version of the switch.
• DHCP indicates the enabled/disabled state of DHCP client functionality.
• BootP Client indicates the enabled/disabled state of BootP client functionality.
• IP Address indicates the IP address of the switch.
• Subnet Mask is the subnet mask of the IP address.
• Default Gateway is the IP address of the gateway for the remote manager.
• MAC Address indicates the MAC address of the switch.
• System Name shows the switch name set by user.
• Location Name shows where the switch located.
• Login Timeout (minutes) defines the web login timeout time of the switch.
• System Up time defines the switch up time after boot up.
3. Scroll down to view additional status information:
• IP Access List Setting
Figure 3-3

NETGEAR ProSafe GS108 Specifications

General

MAC address table	8000 entries
Maximum data transfer rate	1 Gbit/s
Full duplex	Yes
Networking standards	IEEE 802.3ab, IEEE 802.3i, IEEE 802.3u
Copper ethernet cabling technology	1000BASE-T, 100BASE-TX, 10BASE-T
Latency	20 μs
Dimensions (WxDxH)	235.5 x 100.8 x 27 mm
Power requirements	5 V @ 2.8 A DC
Networking features	Ethernet, Fast Ethernet, Gigabit Ethernet
Switch type	Unmanaged
Basic switching RJ-45 Ethernet ports quantity	8
Noise level	0 dB
Mean time between failures (MTBF)	91.500 h
Power consumption (typical)	14 W
Safety	UL (UL 1950), CUL, C-Tick
LED indicators	Link, Power
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	10 - 95 %
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	760 g