GS108T Smart Switch Software Administration Manual
4-28 Configuring the Switch
v1.0, May 2007
.
2. View or specify the SNMP settings as desired:
• Remote Station IP: sets the Community's management station IP address.
• Community String: sets the Community String.
• Privilege: sets the access privilege (read and write) state of the Group.
• Trap Events:
– T1: Authentication Fail: The switch generates an SNMP trap when a host tries to
gain access to the switch but the host's IP is not in the SNMP host table.
– T2: Device Bootup: The switch generates an SNMP trap when it reboots.
– T3: Link Up/Down: The switch generates an SNMP trap when one of its ports
changes its link status.
• Admin State: Enable or disable this community.
3. Click Apply.
Figure 4-47
To Next Page
Loading...
