NETGEAR ProSafe GS108 User Manual

GS108T Smart Switch Software Administration Manual
4-38 Configuring the Switch
v1.0, May 2007
• Respond ID Frames Receive: Indicates the number of EAP Resp/Id frames that have
been received on the port.
• Respond Frames Receive: Indicates the number of valid EAP Response frames received
on the port.
• Request ID Frames Transmit: Indicates the number of EAP Req/Id frames transmitted
via the port.
• Request Frames Transmit: Indicates the number of EAP Request frames transmitted via
the port.
• Invalid Frames Receive: Indicates the number of unrecognized EAPOL frames that have
been received by on this port.
• Length Error Frames Receive: Indicates the number of EAPOL frames with an invalid
Packet Body Length received on this port.
• Last Frame Version: Indicates the protocol version number attached to the most recently
received EAPOL frame.
• Last Frame Source: Indicates the source MAC address attached to the most recently
received EAPOL frame.
3. Click Apply.
Statistics
The DOT1x Statistics page contains information packets received on a specific port.
1. Click Statistics in the blue navigation panel. A screen similar to that shown below appears.

NETGEAR ProSafe GS108 Specifications

General

MAC address table	8000 entries
Maximum data transfer rate	1 Gbit/s
Full duplex	Yes
Networking standards	IEEE 802.3ab, IEEE 802.3i, IEEE 802.3u
Copper ethernet cabling technology	1000BASE-T, 100BASE-TX, 10BASE-T
Latency	20 μs
Dimensions (WxDxH)	235.5 x 100.8 x 27 mm
Power requirements	5 V @ 2.8 A DC
Networking features	Ethernet, Fast Ethernet, Gigabit Ethernet
Switch type	Unmanaged
Basic switching RJ-45 Ethernet ports quantity	8
Noise level	0 dB
Mean time between failures (MTBF)	91.500 h
Power consumption (typical)	14 W
Safety	UL (UL 1950), CUL, C-Tick
LED indicators	Link, Power
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	10 - 95 %
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	760 g