The Intelligent Surveillance Solution
NUUO NVR/DVR/Hybrid NDVR System
- 73 -
Install PTZ cameras and follow the instructions of the camera manufacturer. A PTZ camera is usually
connected to the PC with RS-485/RS-422.
Check the box on the camera list to activate the PTZ control function of a PTZ camera.
Basic Setting: Select the camera model, com port, baud rate, and address according to your PTZ camera.
Note: If the camera model is an IP PTZ camera, you can work PTZ function directly without the com port,
baud rate, and address settings.
Advanced Setting: You may setup the pan speed, tilt speed, zoom speed and auto pan speed. Adjust the
settings by dragging the bars.
Miscellaneous:
Patrol Group: You can setup the Patrol Group, please see page 25 for detail.
Default PTZ Preset: By enabling this function, the PTZ camera will automatically go back to a default
preset point when no PTZ commands are under action. To enable this option, check “Back to PTZ
preset after idle” and define idle periods and a default preset point.
User-Defined Preset: User-Defined Preset for the analog speed dome can trigger the extra-function of
the speed dome itself, for example auto-tracking, login menu of camera…etc. You can refer to the
detailed description of each analog speed dome on its user manual.
Step1: Type the Preset Name.
Step 2: Type the Preset Number.
Step 3: Select the Preset Type.
Step 4: Press the buttons to Add, Delete, or Update preset
setup.
To Next Page
Loading...
