Olivetti PR2 E - FRONT TAB OPENING CHECK AND ROLLER GEAR ADJUSTMENT

Y100250-48-6
8.5 FRONT TAB OPENING CHECK
MACHINE CONDITION:
Rear frame assy closed and carriage moved completely to the right.
OBJECTIVE ADJUSTMENT:
Distance between the front tab and print bar.
PROCEDURE:
After making sure that the tab is adjusted correctly (as indicated in the previous section), close the rear
frame assy and then move the carriage to the right. Using a probe, check that the point of the tab is
located at a distance between 8 and 11 mm from the print bar, measuring at 5-6 cm. from the left edge
of the print carriage.
Fig. 8-5
8-11