Y100250-44-2
4.2 PRINT TEST
The print test provides a printout of the machine's set-up parameters.
The instructions to run this test are given in section 3.3, Off-line Testing.
4.3 PRINTER SET-UP
The Set-up environment should only be accessed by the service engineer and programmer since some
of the selectable parameters are used to customize the machine or option installed and must therefore
not be changed. An incorrect intervention by the operator could cause printer malfunction.
4.3.1 ACTIVATING THE SET-UP
To enter the set-up environment, power off the machie and then power it back on again while pressing
the ST1 (Station 1) and ST2 (Station 2) buttons simultaneously.
Upon completion of the printer reset phase, load an A4 sheet of paper: the machine will print a line with
ta description of the functions of all the keys in this environment.
The flow charts on the following pages indicate the different ways in which the various set-up
environments can be accessed.
4.3.2 SUPPORT SOFTWARE
The software tools include all tools and languages that the product needs for the environments in which
it will be used.
- Promotional demo
The program features an appropriate product presentation format and exploits all the operating
modes and options available.
It highlights the features and performance offered by the printer in every configuration and
optimizes the operational cycle so as to reach the maximum performance obtainable.
- Drivers
Based on the Olivetti native protocol, they integrate the entire range of features handled by
industry-standard applications.
- Reference command sets STD 12/14 PR2E
- DLL driver provided WIN NT 4.x/2000, WIN 95/98
- Environment DLL WOSA
- Set-up management software
A specific program developed for set-up management on-line. It displays the product's set-up
parameters and makes it possible to change them, handshaking included.
- Font and logo management software
A program used to create unusual graphical representations or special fonts.
To Next Page
Loading...
