Y100250-4
3-20
3.7.5.2 REPLACING THE RIBBON CARTRIDGE WITH THE MACHINE POWERED OFF
The ribbon cartridge can be changed with the machine powered on and by following the procedure listed
below:
- Open the printer cover; printing stops automatically.
- Lift the upper mechanical assembly by using the appropriate lever.
- Remove the used cartridge and replace it with a new one as previously described.
- Lower the upper machanical assembly by using the appropriate lever.
- Close the printer cover.
Note: DO NOT move the printhead manually.
3.7.6 PAPER JAMS
The paper could jam along its path inside the machine.
Jamming could be caused by one of the following:
- Obstructed paper path (for example, residual pieces of paper)
- Paper skew
- Paper weight or size non-compliant with the specifications
- Crumpled, folded or badly preserved paper
- Stapled paper or with paper clips (this can seriously damage the machine)
- Multicopy forms where the sheets are poorly glued together.
The areas where jams are more likely to occur are:
- front document feed slot
- inside the printer
- rear document output slot
To Next Page
Loading...
