Service ManualY100250-4 4-25
This calibration sets the distance between the left edge of the and the first print character.
The left margin value will always be used, without the need for set-up configurations.
Proceed as follows to perform this calibration:
1. Power on the printer with its cover open and while holding down the three buttons on the console.
2. Wait for an audible signal to indicate that the printer has switched to the calibration and adjustment
mode.
3. Press Local and wait for the machine to complete its reset.
4. Press Station 2.
5. Press the Station 1 button until hearing a prolonged dual-tone signal (different from the previous).
6. Insert an A4 sheet of paper and wait for the printed page. Check that the left margin has the required
measurement.
7. The minimum distance between the left edge of the document and the beginning of the character
must be a maximum of 0.5 mm with console calibration completely to the left. If this condition is not
met, recalibrate the photosensor.
8. Check according to the requirements of step 6.
9. By pressing Station 2, move the left margin rightward until reaching 6.95 ± 0.55 mm defined by the
DIMA code 473284Z (check made by inserting an A4 sheet of paper)
10. Press Local twice.
To Next Page
Loading...
