Olympus EPOCH 650 - Page 109

DMTA-10055-01EN, Rev. A, February 2015
Software Interface 97
Range, and Delay. These parameters are crossed out when the Cal Lock
function is turned On.
• Radix Type
Used to select the format used by the instrument to display numeric values
(radix) and the date.
• Date Mode
Used to set the date format. You can choose between the dd/mm/yyyy and
mm/dd/yyyy formats.
• File Open & Recall
— On
— Off
• Communications Protocol
Used to select command type for remote/PC communication with the
instrument (Multi Char or Single Char). When communication with the
Olympus GageView Pro PC software, Multi Character mode must be
selected.
• Communications Device
Used to select the type of remote/PC communication (USB or RS-232). When
communication with the Olympus GageView Pro PC software, USB mode
must be selected.
• Baud Rate
Activated only when you select RS232 in the Communications Device box.
Baud rate on instrument must match baud rate on PC.
— 2400
— 9600
— 19200
— 38400
— 57600
— 115200
• Test
— On
— Off
• Corrosion Gage
Enables or disables the optional corrosion gage software.
—On