DMTA-10055-01EN, Rev. A, February 2015
Powering the EPOCH 650
43
2. Powering the EPOCH 650
The EPOCH 650 ultrasonic flaw detector is designed to operate using either of two
power supply sources:
• Internal lithium-ion battery
• Directly from the EPOCH charger/adaptor
Whatever source is selected, the power on/off procedure is the same.
To power on or off the EPOCH 650
1. Press the Power button to turn on the EPOCH 650 (see Figure 2-1 on page 43).
Pressing this key once causes an initial beep, followed by the instrument startup
screen. Approximately 5 seconds later, a second beep indicates that the system is
ready for use.
Figure 2-1 Location of the EPOCH 650 power key and indicator
To Next Page
Loading...
