Olympus EPOCH 650 - Using the Grid

DMTA-10055-01EN, Rev. A, February 2015
Chapter 10 218
— High Range Thickness
All measurements above this value are colored green.
All measurements between the Low Range Thickness value and the High Range
Thickness value are colored yellow.
To configure the grid size and color
1. In the Grid setup page, press NEXT to highlight the Grid Size field.
2. Select Half Size (P1 key) or Full Size (P2 key).
3. Press Next to move to the Display Color field.
4. Select Mono (P1 key) or Color (P2 key).
If you select Color, the Low Range Thickness and High Range Thickness fields
appear.
 Enter a value into each field.
5. Press to return to the live screen and display the grid.
10.5.3 Using the Grid
Since Grid View displays the data contained in a file, there are two ways you can view
this data:
• Adding data to a file from the live screen while making measurements
• Reviewing saved data in a file.
To use a grid in the live screen
1. Choose File > Open and open the file you want to use.
2. Navigate to the Display Setup group menu (3/5).
3. Press Grid (P3 key) to display the Grid controls (see Figure 10-25 on page 219).
The grid controls include the arrow buttons (see “To use the arrow buttons” on
page 220), Grid button, and Save button.
4. To immediately begin populating the grid with data, make a measurement and
press Save (P7 key).
• In an incremental file, the file ID is incremented, the data is saved to that
location, and a new row in the grid is created and displayed to show the
newly saved data.