Olympus EPOCH 650 - Interface Gate; Activating the Interface Gate

DMTA-10055-01EN, Rev. A, February 2015
Software Features and Options 259
Figure 11-23 Calibration data in collect mode
11.5.2.2 Crack Sizing
The EPOCH 650 automatically collects A
max
, T
1
, and T
2
and calculates a “k factor”
from the known reference height d
r
. These three collected values (A
max
, T
1
, and T
2
)
are displayed on the screen in their respective positions using “□” marks.
Once you are satisfied with the collected calibration data, press P5 to move from
Calibration mode to Inspect mode (see Figure 11-24 on page 260).