Olympus EPOCH 650 - Figure 10-5 Advanced (Create

DMTA-10055-01EN, Rev. A, February 2015
Chapter 10 196
5. Press NEXT to highlight the Setup field.
6. Press Ok (P1 key).
7. In Create page two, press a parameter key (P1–P7) to select a type (see Figure 10-5
on page 196):
•SEQ
•SEQ+CP
•2D
•2DEPR
•2D+CP
•3D
• BOILER
8. Enter the required (and optional if desired) information for the selected type.
9. Press NEXT to highlight the Create button.
Figure 10-5 Advanced (Create page two)
10. Press Create (P1 key) to exit the setup page and create the file.