Olympus EPOCH 650 - Figure 10-8 the Details Page

DMTA-10055-01EN, Rev. A, February 2015
Data Logger 199
Figure 10-8 The Details page
3. Press Done (P1 key) to return to the Open page or press to return to the main
screen.
Viewing Setup and Waveform Data for Saved IDs in a File
Once data has been saved into a file, you are able to view contents of the saved data.
The waveform and basic setup parameters are stored on one screen, and the complete
setup information on another screen.
To view saved data
1. Choose File > Open, and then select the specific file that you want to view.
2. Press Contents (P3 key) to view the saved waveform and the basic setup data.
The ID of the file being viewed is displayed at the top left corner of the screen (see
Figure 10-9 on page 200).