DMTA-10055-01EN, Rev. A, February 2015
Chapter 12
298
Figure 12-1 Removing the lithium-ion battery
12.2 Instrument Cleaning
When needed, wash the instrument only with mild soap and water on a damp cloth.
12.3 Verifying O-Ring Gaskets and Seals
The EPOCH 650 ultrasonic flaw detector contains seals that are used to protect the
instrument’s internal hardware from the environment. These include:
• Battery compartment cover seal
• Side door seal
• Membrane vent
• Main o-ring seals between the top and bottom half of the instrument and the
aluminum heat-sink band
• Conventional transducer gasket
Regularly clean and verify the state of the above seals and gaskets to ensure the
integrity of the hardware protection.
Battery
compartment
cover
Thumb screws
(2)
Battery
Pipe stand
To Next Page
Loading...
