Olympus EPOCH 650 - 9.11 Common Angle Beam Calibration Block Diagrams; Figure 9-30 the ASTM E164 IIW Type Calibration Block (P;N: TB7541-1)

DMTA-10055-01EN, Rev. A, February 2015
Calibration 181
2. Choose Trig > Diameter, and then enter the outer diameter of the inspection
piece.
3. If using Trig > CSC = Outer Dia, choose Trig > Thick and then enter the wall
thickness of the inspection piece.
9.11 Common Angle Beam Calibration Block Diagrams
Figure 9-30 on page 181 to Figure 9-36 on page 186 illustrate calibration blocks
commonly used with angle beam probes.
Figure 9-30 The ASTM E164 IIW type calibration block (P/N: TB7541-1)
10.16 cm(4 in.)
.050 TYP. TOLERANCE
NON
-CUMULATIVE
NO
LUCITE PLUG
22.86 mm
(9 in.)