Olympus EPOCH 650 - Quickly Adjusting Basic Gate Parameters

DMTA-10055-01EN, Rev. A, February 2015
Adjusting the Pulser/Receiver 113
5.5.2 Waveform Rectification
The EPOCH 650 ultrasonic flaw detector can operate in one of four different
rectification modes that you can select using the Rcvr > Rect parameter: Full, Half+,
Half-, or RF (unrectified).
The RF mode is not active while operating in special software feature modes, such
as DAC mode or Peak Memory.
To adjust the Rectification
 Choose Rcvr > Rect, and then change the rectification setting.