DMTA-10055-01EN, Rev. A, February 2015
Chapter 10
194
Figure 10-3 File name edit
Special characters such as spaces, decimals, slashes, and punctuation are not
permitted in the Filename field.
5. For each of the next three optional fields (Description, Inspector ID, Location
Note) press NEXT, then Edit (P1 key) to enter information.
6. If the File Type is INC:
a) Press NEXT, then Edit (P1 key) to enter an optional ID Prefix.
This prefix will save as part of the ID but will not increment.
b) Enter a Start ID for the INC file.
7. If the File Type is CAL, press NEXT, then Edit (P1 key) to enter a calibration ID.
8. Once you have completed the file setup, press NEXT to highlight the Create
button.
9. Press Create (P1 key) to exit the setup page and create the file.
To Next Page
Loading...
