Omron CP1L - Page 749

715
PLC Setup Appendix G
Origin Return Settings
Inverter Positioning 0
Basic Settings
Name Default Settings When setting is read
by CPU Unit
Internal
address
Bits Settings
1 Speed 0 pps
(disabled)
1 pps At start of operation 289 and
288
00 to 15 0000 0001
hex
: :
100,000 pps 0001 86A0
hex
000F 4240
hex
2 Acceleration Ratio 0 (disabled) 1 (pulses/4 ms) At start of operation 290 00 to 15 0001Hex
: :
65535
(pulses/4 ms)
FFFF hex
3 Deceleration Ratio 0 (disabled) 1 (pulses/4 ms) At start of operation 291 00 to 15 0001 hex
: :
65535
(pulses/4 ms)
FFFF hex
Name Default Settings When setting is read
by CPU Unit
Internal
address
Bits Settings
1 Use inverter positioning Do not use Use When power is turned
ON
416 00 to 03 0 hex
Do not use 1 hex
2 Gain 0: 10 (0.1 incre-
ments)
0: 10 (0.1 incre-
ments)
When power is turned
ON
418 00 to 15 0000 hex
1 (0.1 increments) 0001 hex
: :
65,535
(0.1 increments)
FFFF hex
3 In-position range 0: 1 0: 1 When power is turned
ON
419 00 to 15 0000 hex
1 0001 hex
: :
65,535 FFFF hex
4 Min. output value 0: 1 0: 1 When power is turned
ON
420 00 to 15 0000 hex
1 0001 hex
: :
65,535 FFFF hex
5 Max. output value 0: 2,000,000 0: 2,000,000 When power is turned
ON
421, 422 00 to 15 00000000
hex
1 00000001
hex
: :
4,294,967,295 FFFFFFFF
hex
6 Error counter overflow
detection value
0: 10,000 0: 10,000 When power is turned
ON
423 00 to 15 0000 hex
1 0001 hex
: :
32,767 7FFF hex
7 Error counter alarm
detection value
0: 10,000 0: 10,000 When power is turned
ON
424 00 to 15 0000 hex
1 0001 hex
: :
32,767 7FFF hex