PART 1: CX-Programmer
CHAPTER 3 – Project Reference OMRON
CX-Programmer _Page 42
horizontally in the Diagrams Tab Page (the default setting is OFF: previously used vertical display). By using
the horizontal display mode, the number of instruction rungs that can be printed and displayed on one screen is
increased, improving the readability of the program. At the same time, the number of printed pages can be
reduced.
Note that it may not be possible to fit all of the requested information on the right of the instruction - the height
of a cell is not determined by these choices. The 'Attached comment' is always shown first (i.e. highest priority),
followed by the 'Symbol Comment' and then the descriptions.
Show Program/Section Comments
When the Show option is checked, every first rung in a section will show the Program Comments and Section
Comments at the top of the ladder program. Double-click the comments to edit them.
To Next Page
Loading...
