CX-Programmer_Page (xxiii)
Unit Version 1.0
All functions that are supported by unit version 4.0 or later of the CJ1 CPU
Units are supported by unit version 1.0 of the CJ2 CPU Units.
CX-Programmer version 8.0 or higher must be used to enable using unit
version 1.0 of the CJ2 CPU Units.
Functions Supported by Unit Version for CJ2M CPU Units
Functions Added for Unit Version 2.0
CX-Programmer version 9.12 or higher is required to use the following
function added for unit version 2.0.
• Support of the CJ2M-MD211/212 Pulse I/O Modules.
Functions Added for Unit Version 1.0
The functions supported by unit versions 1.0 to 1.3 of the CJ2H CPU Units
are supported except for the following functions from unit version 1.1.
• High-speed interrupt function
• Synchronous unit operation
To Next Page
Loading...
Need help?
General