OMRON PART 1: CX-Programmer
CX-Programmer_Page (vi)
Force-setting/resetting Bits in EM Area
Previous version (version 8.2) New version (version 8.3)
Bits in the EM Area could be force-set/reset in
CJ2H CPU Units only for specific EM Area banks
for which automatic address assignment was
used.
With CJ2H CPU Units with unit version 1.2 or
later, PLC • Memory Allocate • EM Memory
Settings can be used to specify the EM Area
banks for which bits can be force-set/reset. (The
first bank is specified and force-setting/resetting
bits is possible in that bank and all banks
following it.) This is called the EM Area force-
setting/resetting function.
Searching for Symbol Names and Displaying Usage Locations from Cross-reference Pop-
ups
Previous version (version 8.2) New version (version 8.3)
Searching from cross-reference pop-ups was
possible only for address specifications. (To
search for symbols, you had to click the Browse
button and search for symbol names from the
Symbol Search Dialog Box.)
Symbol names can be specified directly in cross-
reference pop-ups to display a list of locations
that use the address of that symbol.
To Next Page
Loading...
