OMRON PART 1: CX-Programmer
CX-Programmer_Page (vii)
Version 8.2 Upgrade Information
Functionality Improved from Version 8.1 to 8.2
Connecting Online to the PLC through an NV-series PT*
Previous version (version 8.1) New version (version 8.2)
It was not possible to connect online from the
CX-Programmer through an NV-series PT to a
PLC connected to the NV-series PT.
It is now possible to connect online from the CX-
Programmer through an NV-series PT to a PLC
connected to the NV-series PT.
*Functionality improved in version 8.21 over version 8.20.
CP1E CPU Unit Supported for Connecting Online to a PLC via an NS-series PT
Previous version (version 8.1) New version (version 8.2)
With a CP1E CPU Unit, it was not possible to
connect online from the CX-Programmer through
an NS-series PT to a PLC connected to the NS-
series PT.
With a CP1E-N@@D@-@ CPU Unit, it is now
possible to connect online from the CX-
Programmer through an NS-series PT to a PLC
connected to the NS-series PT.
Compatible PLC Models
The functionality improvements are supported for CP-series CP1E CPU Units
with unit version 1.0.
Online Connection to the PLC via an NS-series PT
Previous version (version 8.1) New version (version 8.2)
An online connection from the CX-Programmer
through an NS-series PT to a PLC connected to
the PT was not possible.
An online connection from the CX-Programmer
through an NS-series PT to a PLC connected to
the PT is possible when the PLC is connected to
the PT using a serial connection, Ethernet
connection, or Controller Link connection.
To Next Page
Loading...
