Omron CX-PROGRAMMER V9 - Page 71

OMRON PART 1: CX-Programmer
CX-Programmer_Page (xxxvii)
• 1 to 1 Type
(2)
(3)
(4)
(1)
(6)
(5)
4
1b
2
2
3
1c 1d
3 4
1a 1a 1a
1a
1b
1c
1d
Master node Slave node
(5) Participating nodes
(1) Area and Start Word
(2) Master, Common Send Words
(3) Master, Individual Send Words
(Same as (3)).
(4) Slave, Send Words
(Same as (4)).
(Same as (4)).
(Same as (3)).
Features of 1 to 1 Type 1:N Allocation
•
Data communications are 1:1 between the master node and slave nodes.
•
All slave nodes receive part of the data sent by the master node. In addition,
each slave node receives unique data from the master node (see a to d in
figure).
•
The master node receives all data sent by the slaves. The data sizes are
fixed for all nodes.
•
Slaves do not send or receive data with other slaves.
•
One area is selected from the bit-access areas (e.g., CIO Area) o
r
word-access areas (e.g., DM Area).
•
Data link areas are allocated in ascending order of node addresses.
•
Data link participation can be specified for each node.
• Chain Type
(1)
(2)
(3)
(5)
(4)
No. Item Description of function
(1) Link Area and Start
Word
Set the area and the start data link
word.
(2) Master, Common
Send Words
Set the send size of the data to send
from the master node to all slave
nodes. The same size of data is sent
to all nodes.
(3) Each Node,
Receive and Send
Set the send size of data for each
node to send to the next node.
(4) Nodes Set the nodes participating in the data
links.
(5) Status start word Set the start word to store data link
status. (If 0 words is set, the default
area will be used.)
1 to 1 T
yp
e Settin
g
s
Chain Type Settings
No. Item Description of function
(1) Link Area and
Start Word
Set the area and start data link word.
(2) Master, Common
Send Words
Set the send size of the data to send
from the master node to all slave
nodes. The same size of data is sent
to all nodes.
(3) Master, Individual
Send Words
Set the send size for the master node
to sent individually to each slave node.
(4) Slave, Send
Words
Set the send size of the data sent from
each slave node to the master node.
(5) Nodes Set the nodes participating in the data
links.
(6) Status start
word
Set the start word to store data link
status. (If 0 words is set, the default
area will be used.)