Trajexia Tools interface
PROGRAMMING MANUAL 196
Revision 3.0
5.5 Menu descriptions
5.5.1 Project menu
fig. 23
The Project menu lets you create, load and save Trajexia Tools
projects.
New project
Deletes the project that is on the Trajexia system and starts a new
project on the PC. Trajexia Tools makes a new directory with the
project name that contains the new project file. The name of the
directory must be the same as the name of the project, else the
project can not open.
Load project
Opens a project that is on the PC. Trajexia Tools downloads the
project that is in the PC to the Trajexia system.
The project on the Trajexia system is overwritten. Before you load
to the Trajexia system, make sure that the program on the Trajexia
system has a back-up copy first.
Save project as...
Uploads the project that is in the Trajexia system to the PC and
saves as to a directory on the hard-drive of the PC.
Check project
A check is made between the Project on the Trajexia system and
the PC. The checksums and program content are compared.
Revert to backup...
Whenever Trajexia Tools connects to the MC16 it compares the
project in the controller and on the PC and then makes a backup
copy. Revert to backup can be used when you want to cancel all
modifications done to the project and BASIC programs while
connected to the controller.
I52E-EN-03.book Seite 196 Freitag, 29. Juni 2007 11:55 11
To Next Page
Loading...
Need help?
General
