Trajexia Tools interface
PROGRAMMING MANUAL 204
Revision 3.0
Delete all
Deletes all the programs from the file structure.
Compile
Compiles the current program in the project.
Compile all
Compiles all programs in the project.
Run
Executes the current program in the specified process.
Start stepping
Execute the current program in the specified process in the step
mode (line by line).
Stop
The Stop command stops the program in the TJ1-MC__ controller.
This is not the same as Motion Stop. The program stops at the end
of the CPU cycle. The servo motors maintain position.
Stop all
The Stop all command stops all programs in the TJ1-MC__
controller. This is not the same as Motion Stop. The programs stop
at the end of the CPU cycle. The servo motors maintain position.
I52E-EN-03.book Seite 204 Freitag, 29. Juni 2007 11:55 11
To Next Page
Loading...
Need help?
General
