Examples and tips
PROGRAMMING MANUAL 226
Revision 3.0
fig. 1
1. Click the Intelligent drives button (A).
fig. 2
2. Click the Modify STARTUP program button.
3. At the end of the section created automatically, put your own
application code. Typically variable initialisation and axes
parameters.
4. At the end of the STARTUP program, run your application
programs. It is recommended to run the "SHELL" program,
explained later in this section.
5. Set the STARTUP program to run at power on.
I52E-EN-03.book Seite 226 Freitag, 29. Juni 2007 11:55 11
To Next Page
Loading...
