Panasonic KX-TDA50

Feature Guide 11
1.25.2.2 Calling/Connected Line Identification Presentation (CLIP/COLP) and Calling/Connected Name Identification
Presentation (CNIP/CONP)—by QSIG ..........................................................................................................207
1.25.2.3 Network Direct Station Selection (NDSS) (KX-TDA5920 required)................................................................209
1.25.3 Voice over Internet Protocol (VoIP) Network.................................................................. 212
1.26 Computer Telephony Integration (CTI) Features ...................................................... 213
1.26.1 Computer Telephony Integration (CTI)........................................................................... 213
2 System Configuration and Administration Features ...................... 215
2.1 System Configuration—Hardware.............................................................................. 216
2.1.1 Extension Port Configuration ......................................................................................... 216
2.2 System Configuration—Software ............................................................................... 217
2.2.1 Class of Service (COS).................................................................................................. 217
2.2.2 Group ............................................................................................................................. 218
2.2.3 Tenant Service ............................................................................................................... 220
2.2.4 Time Service .................................................................................................................. 224
2.2.5 Operator Features.......................................................................................................... 228
2.2.6 Manager Features.......................................................................................................... 228
2.3 System Data Control.................................................................................................... 231
2.3.1 PC Programming ........................................................................................................... 231
2.3.2 PT Programming............................................................................................................ 233
2.3.3 Quick Setup ................................................................................................................... 234
2.3.4 Automatic Time Adjustment ........................................................................................... 235
2.3.5 Flexible Numbering/Fixed Numbering............................................................................ 236
2.3.6 Floating Extension ......................................................................................................... 240
2.3.7 Software Upgrading ....................................................................................................... 241
2.4 Fault Recovery/Diagnostics........................................................................................ 242
2.4.1 Power Failure Transfer................................................................................................... 242
2.4.2 Power Failure Restart .................................................................................................... 242
2.4.3 Local Alarm Information ................................................................................................. 242
3 Programming Instructions................................................................. 245
3.1 Introduction.................................................................................................................. 246
3.1.1 Introduction .................................................................................................................... 246
3.1.2 Password Security ......................................................................................................... 246
3.1.3 Entering Characters ....................................................................................................... 248
3.2 PC Programming.......................................................................................................... 251
3.2.1 Installing and Starting KX-TDA50 Maintenance Console............................................... 251
3.3 PT Programming .......................................................................................................... 255
3.3.1 Programming Instructions .............................................................................................. 255
3.3.2 Basic Programming........................................................................................................ 257
3.3.3 System Management Programming .............................................................................. 259
3.3.4 Time Programming......................................................................................................... 261
3.3.5 TRS/ARS Programming................................................................................................. 263
3.3.6 CO Line Programming ................................................................................................... 265
3.3.7 COS Programming......................................................................................................... 269
3.3.8 Extension Programming................................................................................................. 271
3.3.9 Resource/Interface Programming .................................................................................. 277
3.3.10 SMDR & Maintenance Programming.............................................................................278
3.3.11 Card Programming......................................................................................................... 280
4 KX-TDA50 Maintenance Console Operating Instructions .............. 281